The Best Mounting Tv Bracket On Stone Fireplace References. Then, drill holes for the tv’s mounting hardware. As you can see in the photo above, my husband cut the stone wide enough to fit a piece of 2×4 wood, long enough for the bracket we purchased.
Over Fireplace TV Installation/ Stone from www.vultroninstallers.com
The hooks each take a mounting screw about ¼ diameter, which i liked so as to minimize the damage to the stone. We put a strip of tape on the bottom of our tv, where we wanted it to be. Ensure the temperature of the stone stays below 100 degrees fahrenheit.
Hardware For Mounting (Screws, Spacers, Etc., But These Often Come With The Tv Bracket) You May Need A Second Person To Help You Hoist And Place The Tv, For Additional Hands.
Our reason for doing this is to avoid getting neck pain. The hooks each take a mounting screw about ¼ diameter, which i liked so as to minimize the damage to the stone. Ensure that the folding shape is even and bend an inch on one end at.
You Get A Carbide Bit, A Hammer Drill, And Have At It.
Next, locate the mounting bracket. Set the setting of the drilling machine to the h/d or similar setting, especially if the stones are tough. A fireplace nook tv mount like those we’ve reviewed can be made of aluminum, steel, lightweight alloys, or plastic.
Lift The Tv High Enough To Slide The Brackets Into The Connectors On The Mounting Plate.
With a wrench, tighten a bolt at the screw’s end. Stone fireplace edition as with many homes, the fireplace is the focal point of the living room and seems to be the most logical place to hang your new tv. In this case, it was also a very uneven stone surface.
Measure The Distance From The Fireplace To Where You Want Your Tv.
`always check whether the small portion can be easily drilled to mount the tv. Sometimes you can get a stone fireplace tv mount as well. Once you have confirmed that the spot is safe enough to mount your tv, you can begin the installation process:
Our Goal Was To Determine How Far Away We Must Sit From The Tv Mounted Above The Mantle Not To Need To Lookup.
Remove the portion from the tv by removing the screws that hold it to the television. Cut the hanger to 8 inches and fold it into an l shape. Once the wires were properly fed through the opening (check with your mount to make sure it will fit around the wires) the next step is actually installing the mount.
